Wiring a phase converter

The single- phase neutral wire is not required for operation of the converter. Properly ground all electrical equipment. In this video, we show the basic installation techniques of the American Rotary Phase Converter Panel. The idea is to show how easy it is to install , phase.

I am finally getting my American Rotary Phase Converter installed into the new shop which will convert single phase power to three phase.

Static_Phase_Converters View our full line of.

Static converters are low in initial cost and are easy to install.

Follow all local, city and National Electric Codes. Do not use Tfor any single phase loads. Use correct size protection on all loads. Always have phase converter on before starting any 3-phase load. Current is limited by the full load current rating of the phase . The final episode in the diy phase converter series.

The best way, IMHO, is invite the pros to strut their stuff and stand out of the way - video camera in hand. Phoenix Phase Converters , Arizona is the one stop shop for your phase converter needs. A static converter that is too large will not work properly and may cause damage.

Two-speed motors are dual horsepower. Wiring diagrams for TEMCo phase converter lines. Learn to hook up your single phase to three phase converter. The unit used in these videos is an AD series model.

So keep in min some things may vary depending on your specific order for your . Make sure the wire size meets our minimum recommended size. All loads INCLUDING TRANSFORMERS must be DISCONNECTED before starting the phase converter each time. This includes small control transformers that run controls inside your equipment. If you need an economical 3-phase disconnect switch, . If you want to get more details just let me know and. Section 1: Introduction and Installation Notes.

Large single- phase loads may be connected to phases “B” and “C” if the additional current from these loads is taken into account during wiring. Connection of single- phase loads to phase “A” is not recommended.