Hudson Products manufactures air-cooled heat exchangers (air coolers), axial flow fans, tank and vessel process heaters, heat pipe air pre-heaters, and finned tubing. Usually based on the nominal fan diameter minus seal disc area or hub diameter. Note that blade area is not considered.
Pitch Angle Blade tip angle below the horizontal required to do the design work and move air upward.
Hudson fans all rotate clockwise looking into the airflow.
Your source for on Hudson products and services.
H family, which means that the HC .
Standard sizes are available from - feet in diameter for heat. Erosion and chemical resistant . Remove blade clamp bolts, nuts, lock washers, and blade clamp halves from hub. Remove and discard the PVC blade clamp spacers.
Position blade clamp halves on blade neck with chamfered edge toward hub. The leading edge is the rounded portion of the blade. The trailing edge is the thin section of the blade.
Call for the BEST domestic Pricing. We routinely replace fans on BAC, Marley, and Evapco factory-assembled cooling towers with new adjustable pitch, . This manual now includes the latest Hudson standard fans.
Install one fan blade with pitch set at 22ยบ. These new fans deploy different hub and seal disc sizes as shown in the. This same list shows the original fans highlighted.
This means optimizing the fan diameter and number of blades.
Lowest horsepower requirements. The fan should work as close to an efficient operating point as . Most products are stocked at Chesapeake, VA factory. Click on Tuf-Lite III for comparative pricing.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.