Bill asks, My ceiling fan vibrates and wobbles when turned on high speed. There are several possible problems that could cause your paddle. Loose screws on any part of the ceiling fan allow parts to move independently, making the whole thing wobble when the blades get up to speed.
The screws should all be hand tight, but.
A high speed wobbly ceiling fan will strike fear in the heart of anyone standing under.
Not as clean as other methods but it does work go.
Tev Hyman Castro owner of THCElectrical.
Ceiling fans often wobble for reasons other than balance. We show you how to adjust and balance your ceiling fan blades to stop the wobble and rattle. Get your fan running smoothly again in minutes.
As with all machines that have moving parts, ceiling fans will suffer from wear and begin to get loose.
All of the screws had to get tightened down to stop most of the wobbling. As it turns out after much investigation neither the blades nor the motor were out of balance. In fact the issue that was causing the . HomeChannel If your ceiling fan.
Ceilings fans that wobble are not only annoying but can be dangerous.
The wobble may also decrease the life of the fan. Start the fan on its highest speed blowing down (counter-clockwise) and see if the wobble disappears. If the ceiling fan stops wobbling at any point, the last blade you tested is unbalanced . Turn on the ceiling fan and confirm wobbling has stopped. Is your ceiling fan off balance or shaky?
A ceiling fan that is unbalanced and wobbling left and right (back and forth) can be dangerous.
This could mean loose screws holding the blades to the fan housing. Use super glue if you would like to permanently attach the . First, it must be determined if the fan is rocking or wobbling. I can prescribe some actions to straighten that out. Sight along the edges of each blade, checking for warping.
Make sure the fan is installed correctly and that the wobble is not coming from its ceiling mounting.
If it is, then the fan must be reinstalled ASAP. If nothing seems to be wrong or seems to stop the wobble , then try swapping the blades to different locations until the wobble is gone or reduced. If that still does nothing, then . A common sight in most homes is ceiling fans.
My husband said we needed rubber bands that they sell to put around the base of the light fixture. The originals ones had dryrotted which caused the .
No comments:
Post a Comment
Note: only a member of this blog may post a comment.