Powerflex 40 fault codes

For complete troubleshooting information, refer to the. ATTENTION: Power must be applied to the drive to perform the following start-up procedures. Some of the voltages present are at.

Supplemental Drive Information. PowerFlex Adjustable Frequency AC Drive FRN 1.

Electronic Motor Overload Protection description updated.

Fault description for Frevised.

Press the Enter key to save the new value. With flexible enclosure options, and simple programming, they can be installed and configured quickly. We also have packaged drives that provide additional control, power, and enclosure options in standardized designs.

V AC (±) – 1-Phase(1) Input, - 230V 3-Phase Output, NO BRAKE. For external 4-20mA input supply.

It does this by measuring the current going out . Reserved for thru custom firmware. Note the FAULT CODE in the TELEMETRY USER INTEFACE. Check for blocked or dirty heat sink fins.

Additional accessories, options and adapters are available. VP-3 Arm bridge overload pending, War, Average arm current exceeds 1 of nameplate.

VP- , Autotune status fault , Soft, Internal processor error detected during Autotune. VP-4 Autotune logic state, Soft, Internal processor error detected during Autotune. VP-4 Invalid taper spee Soft, Start speed taper speed si . Pwr Brd Chksum Non Resettable.

Incompat MCB-PB, Non Resettable . Replaced MCB-PB, Non Resettable. This fault is caused by an excessive motor load on the output of the drive. This is based off of the motor nameplate full load amps.

OR Hardware enable circuitry failed.

DC bus voltage remained below of nominal for longer than. Monitor the incoming AC line for . Corrective Action : Check to make sure . Updated Control table in Technical Specifications. Removed Bandwidth specification from Control Inputs table in Technical Specifications.

A running drive continues to run but cannot restart until the alarm condition is cleared.

The drive stops and cannot be started until fault condition is cleared.