What else can be wrong, there are couples of thermistor and fuse nearby the blower , beside using the ohm to test that thermistor, can I . SourceCode=Click here for more information on this part, installation instructions a. Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. The thermal fuse cannot be reset.
Ensure the power is still off before troubleshooting, then examine the exhaust duct for obstructions that limited air flow.
You may also want to replace the dryer cycling thermostat along with the thermal fuse.
If this thermostat fails, it will likely . This video provides step-by-step instructions for replacing the blower thermal limit fuse on Samsung dryers. The most common reason for replacing the blower . If your control panel lights up but your dryer w. There is NO need to tear apart the dryer to replace the thermal fuse. The fact that there is too much heat in the housing suggests the possibility that the blower , which pushes hot air through the exhaust, is broken.
Free 2-day shipping on qualified orders over $35.
Buy Whirlpool Thermal Fuse at Walmart. Pull the wires off of the thermal fuse. Used on these Brands: Admiral, Amana, Caloric, Crosley, Hardwick, Jenn Air, Kenmore, Kitchen Ai Magic Chef, Maytag, Modern Mai Norge, Roper, Sears, Speed Queen, Whirlpool,.
Mounts on the blower housing , which can be accessed . Note: Disconnect the power source to your dryer before you conduct this or any other test.
Either unplug the unit from the wall outlet, remove the appropriate fuse from the fuse box , or flip the appropriate breaker in the circuit breaker panel. It is located on the blower housing and cannot be reset. If there is no continuity between the fuse , it is blown and needs to be replaced.
Fuse is located on the blower wheel cover.
Replace if open (no continuity between terminals). There are two leads going to the thermal fuse. Gently remove the wires by grasping firmly on the female end of the stake on connector and pull it towards you.
Look for the thermal fuse on the side of the blower housing just above the vent tube.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.