Radon fan installation location

Radon mitigation standards require that the fan to be placed outside of the living space of the home. Another way to define this is any where outside the conditioned air space of the heating and air conditioning system. So garages, attics and on the outside of the house are the only acceptable locations for fan placement.

Fans placed in attics, garages and outside locations will keep you safe.

Mark hole location on basement floor for PVC vent pipe.

Use demolition hammer to chip out hole for PVC vent pipe.

Pull dirt from under floor with a .

As awareness of this hazard continues to sprea more and more homes, offices and schools are installing radon mitigation systems. PVC pipe will be necessary to the entire process and of course increase the amount of time it takes to complete the installation. All radon vent pipe past or on the discharge side of the radon fan is under high positive pressure. Radon fans are powerful, typically moving 1too 2cubic feet of air per . When installed through the attic space, the radon fan and its electrical components are located within the attic.

This location is more innaccessible to children who may turn the fan off or play with the system components.

Although radon systems installed through the exterior are quiet, . Step – Radon Mitigation System Installation. With the venting system in place the radon mitigation system is then installed in the basement to cap the PVC vent. The monitor system is then installed.

A small hole is then drilled in the floor of the basement and the draw of the fan from the radon mitigation system is checked . The purpose of the backer rod is to hold the semi-fluid caulk in place until it sets or hardens.

Perimeter Channel Drain: A means . Click here to read about our current contests and see . RADON SOLUTIONS IN HOMES: RADON SUMP SYSTEMS – GRG PART 3. The absence of running costs makes the installation of passive sumps attractive, but they are much less effective in reducing radon than active sumps. Figure 16: Sump fan located in an underground box, with just. Many states will provide lists of contractors doing radon mitigation work, and some states have certification programs for radon measurement and mitigation.

Air distribution and ventilation rates can be controlled by the sizing and location of fans and the use of louvered air deflectors.

Flexible couplings should not be used except below and above the fan.