Motor shaft slinger

Hayward pumps are engineered for dependability and performance. Recognized as the industry leader, our line of high performance and medium head pumps lead the way in energy efficiency. NSF and UL rate our pumps are equipped with heavy-duty motors.

Rubber Slingers used on motor shafts limit water and contaminant creepage along the shaft into the bearings.

These slingers are Lincoln Catalog No.

We think they can be used on all makes of motors.

The shaft size listed is the diameter Where the slinger fits.

It is equal to or larger than the shaft . This water motor slinger is designed to use with Pentair Sta-Rite ABG Series, Dyna-Wave Series pool and spa pump. Find Neoprene Shaft Slinger related suppliers, manufacturers, products and specifications on GlobalSpec - a trusted source of Neoprene Shaft Slinger information. See separate instructions to remove the motor from, and replace the motor into, the pumping unit.

Sleeve and spacer replacement procedure. Remove the spacer and water slinger. Do not heat or hammer sleeve off, or motor damage will occur.

V-ring shaft seals utilize centrifugal slinger action to provide effective protection against dry and wet contamination. V-ring seals are unique all-rubber seals for rotary shafts.

They are made entirely of rubber. Ideal for protecting gearboxes, electric motors and drives. It helps keep water out of the motor when the shaft seal begins to fail.

Slip the water slinger off the shaft.

Shaft slingers or seals may be installed on the shaft end of vertical motors to prevent the ingress of dirt and liquid. Ratchet is for counterclockwise shaft rotation when viewed from the top of the motor. The NRR stops the shaft while the pump water column is receding.

As the water flows back into the well and the water level drops below the upper shaft bearings, the. This steady bushing is provided to stabilize the pump head- shaft and center it in the bore of the motor shaft at the lower end of the motor. The bushing should be assembled onto the head- shaft before the motor is installe and left disengaged until the motor is coupled to the shaft.

If motor is received with slinger on bottom . Slide the Inpro Seal over the shaft extension on the drive end until the seal rests firmly against the endshield inside the recessed slinger cavity.

The O-ring on the OD of the seal goes against the motor. Fluid may leak and contaminate vegetation or soil. A tapped drive end shaft and opposite drive end endplate allow the motor to be lifted vertically.

The eyebolt can be easily installed for any desirable lifting configuration. Horizontal Drains On Each End: T-drains conveniently located at each end of the motor allow for condensation to escape.

Extra sealing is provided where the shaft projects through the endplate. Inside the typical washdown- duty motor , sealed bearings fight early bearing failure. Nearly all VFD-driven motors are vulnerable to bearing damage, but for too long the importance of shaft grounding to protect motor bearings has been ignored or . A new Split uKIT simplifies and speeds mounting of the ring on motors with shaft shoulders, slingers , or other end-bell protrusions. As with any other WEG motor , Cooling Tower .