See Catalog Number Explanation (Continued) on page 5. Allen - Bradley distributor or. Decel Inhibit” fault is generated if the drive stops decelerating. PowerFlex Firmware Versions – Standard Control 2. OverSpeed Limit” fault will occur if the speed reaches.
In addition, inlet air temperature must not exceed the product specification.
Maximum Surrounding Air Temperature.
Important: Some drives are equipped with an adhesive label on the top of the. Solid state equipment has operational characteristics differing from those of electromechanical equipment. These drives are easy to integrate and configure.
Our packaged drives provide additional control, power, and enclosure options in standardized designs. Fault Display : HW OverCurrent.
Corrective Action : This indicates that the drive has exceeded 3 of output rated current. OR Hardware enable circuitry failed. This fault can come from many different places at many different times.
You need to find out when the fault actually occurs. Does it happen on power up, during deceleration or acceleration, during normal run, or while sitting idle. The voltage that the drive trips on is 285vac input . This is based off of the motor nameplate full load amps.
What is fault and why is it not in my manual? This means that the drive is not following . This manual is intended for qualified personnel. You must be able to program and operate Adjustable Frequency AC Drive devices.
DPI Parameter Object, Class Code.
IGBT Temp HW” fault is equivalent to the Drive Instantaneous Overload. Guarding Against Electrostatic. NFPA - US National Electrical Code. For complete troubleshooting information, refer to the.
ATTENTION: Power must be applied to the drive to perform the. User-defined fault actions to determine how the adapter and connected. In most circumstances, this fault can be safely turned off.
After turning this fault off, you may see another fault which is causing the load not to change speed properly. Pwr Brd Chksum Non Resettable. Incompat MCB-PB, Non Resettable . Replaced MCB-PB, Non Resettable.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.